Sunday, May 25, 2008

How to Detect Pump Cativation ?


One of the important topic is real life operation, detection of pump cavitation during operation. A pumping system may be designed and constructed for pump cavitation free as well as normal operation. Whenever some parts within pumping system is deteriorated, fluid degradation, suction condition change, pump suction and impeller wear-&-tear, would lead to short term intermittent or long term cyclic or continuous pump cavitation. This cavitation may not easily be detected.

There are several symptoms of pump cavitation. During pump cavitation :
  • Severe noise
  • Drops in flow
  • Power consumption increases
  • vibration
  • instable
Noise could be similar to some solid piece (i.e. rock) passing the pump, popcorn popping and particle hitting metal sheet. Click here to hear pump cavitation. According to researches, high frequency resonances in pump occurred during pump cavitation. Pumping flow may suffer partial drop and increases in power demand. However, these parameter may not be detected easily. Similarly, vibration and instable operation may not be detected without a proper device in place.

There are three ways to detect pump cavitation.

i) Visual & Noise detection.
An experienced operator standing beside a cavitating pump can fairly easily distinguish noise caused cavitation than other machinery noise. However, there are large amount of pumps in a plant, it is almost impossible to locate operator near pumps in order to identify intermittent cavitation.



Courtesy of Wilcoxon Research Inc.

ii) Detection by Vibration level monitoring
Another method to detect occurrence of pump cavitation is continuous monitor vibration level of the pump. The is one the mature method nowadays. The vibration level signal is transmitted continuously to condition monitoring system. It can be programmed to provide signal and alarm to alert operator. Following is vibration trend line shows pump normal operation, partial cavitation, full cavitation before it is shutdown.



The vibration level trend line can be available for preventive maintenance analysis. This method can provide information on early detection of potential of pump cavitation so that maintenance group can take early actions.

iii) Detection by Acoustic Emission (AE) analysis
As high frequency noise is emitted during cavitation, Acoustic Emission (AE) technique in condition monitoring of rotating machinery can be used to detect pump cavitation. AE technique basically providing a AE detector several feet away from the pump to capture acoustic level.



Related Topic

No comments:

Post a Comment